Vantage Pro rattle?

[Tommythewho]

I have a new Vantage pro and after a week of carry and a few uses it has developed a rattle in the pivot pin area, only when closed. I rattles when it is shaken in the direction parallel with the pivot pin. Has anyone else eperienced this, know of the fix? Thanks,
Tom

 

[Sithus1966]

It's probably just the stop pin inside, nothing to worry about. I suppose if you wanted to open it up and add a little grease in there to keep it from rattling. Other than that there is really nothing to fix.

 

[365KV]

On the back side of the knife there is a spacer in between the two liners. If you remove the clip and take off the scale without the Buck Emblem you will see the head of a torx screw that is used to pull the two liners together sandwiching the spacer. What I found was that the screw wasn't tight enough on my knife therefore causing the spacer to rattle in between the liners. I suspect this is probably the same for with your knife.

 

[Tommythewho]

Thanks for the help!