Victorinox backspring 3-d "Phillips"

M

Mora2013

Joined
Dec 1, 2013
Messages
311
Does anyone know if the victorinox backspring Phillips 3-d screwdriver satisfies the DIN/ISO 6250 or 8764 standards? I'm curious if I can effectively use this on JIS screws.
 
I don't know what a "backspring" phillips is, the backlayer phillips head is not the same as the front side attached phillips which satisfies the 8764 crosshead standard and can do JIS screws. It is a JIS driver, to be more accurate in label.

The back layer one is a standard phillips. *edit: apparently, the back layer Phillips has gone through 5 different variations and the latest version does satisfy 8764 and I guess is a phillips that can do JIS heads.

http://www.sakwiki.com/tiki-index.php?page=Screwdriver-Phillips
 
Last edited:
wensynch said:
I don't know what a "backspring" phillips is, the backlayer phillips head is not the same as the front side attached phillips which satisfies the 8764 crosshead standard and can do JIS screws. It is a JIS driver, to be more accurate in label.

The back layer one is a standard phillips. *edit: apparently, the back layer Phillips has gone through 5 different variations and the latest version does satisfy 8764 and I guess is a phillips that can do JIS heads.

http://www.sakwiki.com/tiki-index.php?page=Screwdriver-Phillips
Click to expand...


Yes, I did mean backside/backlayer Phillips. I looked at the link you provided. Not that I don't believe you, but I didn't see a reference to the din 8764 standard?
 
I'm waiting for an answer. But this is the first response:

Good Afternoon,

Thank you for contacting us. I do not know the answer to this and have sent a message to our product team to get this info for you. I will get back to you shortly with this!


Sincerely,
Customer Support
Victorinox Swiss Army
 
I got the final response copied below. Now, i specifically asked about the rambler, OHT, and the bits from the cybertool. It does seem that the response lists specific PH sizes that are not accurate, as I can't imagine an OHT backside Phillips fitting into a PH0 screw, but nevertheless, if they are DIN 8764 compliant, I'm sure I can figure out which size screw they fit snugly in.



--------------
Good Morning,


Thank you for your patience with this inquiry. Here is the information my product team gave me. These are all DIN ISO 8764-1 compliant.

0.6363 Rambler
One Philips screwdriver suitable for PH0 and PH1 (DIN ISO 8764-1)

0.8463.MW3 Trailmaster one hand (Trekker)
One Philips screwdriver is suitable for PH0 and PH1 (DIN ISO 8764-1)

Cybertool
Philips screwdriver for PH0 (DIN ISO 8764-1)
Philips screwdriver for PH1 (DIN ISO 8764-1)

I hope this helps. Please contact us if you have any questions at 1-800-442-2706.

Sincerely,
Customer Support
Victorinox Swiss Army
 
You must log in or register to reply here.
Back
Top