Originally posted by foxjaw
Surely, Ya'll have more to say on the Village made Khukris besides Uncle Bill
Well those of us that have been around a awhile don't like to say too much about the village models.
Just wait until they come on sale!!!! I remember the 1st sale of villagers.
I was pretty new here myself then and wanted to be nice and polite so as to be accepted as a newbie in this forum.
Sheeesh!!!! Sheeesh!!!! Those village khuks went like they were made of 24 karat GOLD!!!!
I never saw such backstabbing and whinining and wheedling!!!! It was shameful I tell you!!!! Absolutely Shameful!!!!
Sheeesh!!! The old timers at the time acted as if they had never heard of one another let alone became buds online here. You know what I mean?!?!?!?
Just when you think you can trust someone and they throw up an entirely new and much different character as to what they normally portrayed!!!!!
All kidding aside............

They're the absolute best bang for the buck that H.I. has IMO.
No, they aren't finished too well, but they do represent what you would get if you went to a kami in Nepal and asked him to make you a khukuri. And since you commisioned it you would probably have the right to ask for a full tang instead of a partial, specially if you brought your own spring.

There's nothing wrong with the partial tangs that a few minutes with a drill to fit your pin size and a brass or other soft metal pin a couple of inches long. Drill a hole through the handle and tang crosswise, insert pin, cut to length and then peen it over and file the rough edges off. The handle should last as long as the khukuri now.
I have 3 villagers at present I think. A chiruwa AK is in the trunk of the car, the village BAS is setting by the front door and my favorite 17" steel mounted villager is setting, actually standing up beside me along with my 21"+ Chitlangi, my YCS, my Malla, my BGRS and a Royal Dhankuta.
And you take your chances with a village khuk. They're usually very well made and most are full tang.
Sometimes a village model isn't quite up there in hardness, but what it lacks in edge holding it makes up for in pure toughness.
My 17" Steel mounted Villager has earned a place among my fancy favorites. I can chop seasoned Blackjack Oak with it and the edge doesn't roll, something that can't always be said of knives costing a whole lot more!!!!
I also like the village models because they usually come in a bit thinner than the standard H.I.Model's.
They truly do represent what the average village person gets when they visit their local kami's shop in Nepal.
They're rough, tough and will work like hell for many, many years. Nothing more can be asked for IMO.
