Walnut handle clip point hunter/skinner or EDC

Ochs

Ochs

Joined
May 5, 2010
Messages
411
This is what I call the Stine’s Hill Skinner and this one went out recently to an avid hunter up in Washington State with a leather sheath. Here are some of the details on this knife which is 7-5/8” overall:

Blade is 5/32” thick with 3-1/8” edge made of CPM S30V with satin hollow ground, differential hand rub and a rounded polished back edge. Heat treat is Paul Bos with 59+/- HRC.

Handle is presentation grade Walnut with Martin brass star pins, brass hardware and black liner.

Thanks for looking!
Eric


Sorry about the fuzzy on the blade. :rolleyes:
picture.php


picture.php


picture.php


picture.php
 
no doubt that little knife will lock right into your hand. Looks uber comfy.
There's a definite Lumliness here, like I mentioned to you, but just a little bit. The rest is all you:thumbup::cool:
 
Thanks, guys from my experience it is uber comfy. :D In my book good blade is only half a knife.

Eric
 
You must log in or register to reply here.
Back
Top