Walnut hunter

Ben Breda

Ben Breda

Joined
May 20, 2012
Messages
24
Hello all,

Here is a 5.5" Walnut hunter I finished a little while back. It has a W-2 blade, differentially heat treated with clay. The handle is sculpted (kind of hard to see in the pic) with a domed pin, stainless guard, and copper spacer. The hand stitched sheath completes the package. All comments welcome, enjoy.

24973408551_87ab3ecdc5_b.jpg
 
That's a fine hunter, Ben! Thanks for sharing:thumbup:
 
Love it. Big fan of your work Ben. This one looks so similar to one I'm working on :).
 
That is a sweet looking hunter, Ben. Has all the right curves. Like the size. Good to see you back in action. :thumbup:

- Joe
 
Really nice Ben. Love all the materials you used. Thanks for showing it.
 
Looks really clean, which is typical of all your knives I have handled.
You make the sheath?
 
Really nice Ben! I hope the leg is doing better. Probably need to go full time with knifemaking, it's obviously safer.

Bob
 
Wow, thanks again for all the positive comments! Really glad you like this one.

billf said:
Very nice job Ben !

like the guard treatment especially

Bill Flynn
Click to expand...

Matthew Gregory said:
Agreed. The copper really sets it off!! Beautiful knife.
Click to expand...

Thanks! I thought the copper, Walnut would be a good combo

RangerBobTX said:
Really nice Ben! I hope the leg is doing better. Probably need to go full time with knifemaking, it's obviously safer.

Bob
Click to expand...

Thanks Bob, it's doing pretty good. I think you're right, knifemaking is much safer!
 
So fresh and so clean! ;) Very beautifully made, love the sheath too! :thumbup: I really hope you post more of your work here. :)

~Paul
My YT Channel Lsubslimed
... (It's been quite a while since I've posted any new vids)
 
You must log in or register to reply here.
Back
Top