was asked if i would try a razor

[butcher_block]

so here one is 1of 4
forged W1 1/4 inch thick spine
G10 with iron wood spacer
stainless stop pin
3/16 folder pivot with phos.bronze washers

the blade was flat ground to a wedge heat treated im my kiln quenched in parks (thanks deker for bring it over for this) cryoed then tempered

i finish ground the blade on 2 inch wheel for that great deep hollow
these pictures are shot before i replaced the pivot screws with new ones (scuffed the ones in it up while shaping handles)

i have not sharpened this one yet but i hope to get that done later today
anyhow here are the shots thanks for looking if your looking for a shot i have not taken yet let me know and i can work on getting the pic taken

 

[indian george]

Nice job.:thumbup:I been planning to make myself one, too.

 

[TekSec]

Very nice, Butch!

 

[mmmotorcycle]

It will be one razor sharp razor!

 

[bjalongi]

Now, I would surely cut my throat with that meanie! very nice.

 

[butcher_block]

yes the one thing i have found is i used to think the hunters i made were sharp till i started working in the kitchen knife stuff
now with the razors its even more spooky how sharp i can work them to. the + of all this is now all my other blades will get sharper from learning new ways to hone the blades and the angles of the bevels

 

[Lucky Bob]

How much would one of those go for? Do I even want to know?

 

[Nowicki]

Vary nice. Looks sharp

 

[butcher_block]

not yet but soon very soon

 

[SteelSlaver]

Nice job looks really great.

 

[BRAMEL]

OH Snap!!! Make me one of those, with blaze orange G10 and I'll be all over that....like a fly on a tu....

Very nice work.

 

[Shawn fu]

Very nice,Butch-I love how drastic the hollow grind is-very cool,thanks for sharing:thumbup: