Washer size of Delica?

sharp_edge

sharp_edge

Gold Member
Joined
Jul 30, 2015
Messages
5,920
One of the washers flew off to the floor when I tried to reassemble my zdp-189 Delica and man, where the heck it went? I sweep the floor to no avail. Does anyone know the size of the washer? Any chance that places like HomeDepot carry replacement washers? Or if I ask Spyderco CS Dept, will they send me one or even better a pair? Both washers appear to be cupped but the knife was still very smooth. Currently it is with no washers but still works though not as smooth as before.:D
 
Believe or not, I found the lost washer. Took me a good half an hour to reassemble the little knife. The spring jumped out of position before I could put back the liner. Finally taped the spring in position and after the liner was put back then removed the tape. That worked out nicely.
 
Both washers should be the same.
Just for reference, one of mine measured .004" thick, .155" ID, .317" OD.
This is a well used hap40 delica.
I assemble everything except the lock bar, then add it last.
 
jpm2 said:
Both washers should be the same.
Just for reference, one of mine measured .004" thick, .155" ID, .317" OD.
This is a well used hap40 delica.
I assemble everything except the lock bar, then add it last.
Click to expand...

This is the key. Thx for the washer info.
 
You must log in or register to reply here.
Back
Top