waterjet companies?

[Sam Salvati]

I GLwJ was around, then some new guys came around too, anybody have a list of the waterjet guys on BF?

 

[12345678910]

http://www.bladeforums.com/forums/showpost.php?p=8697670&postcount=3

 

[KnifeMaker.ca]

A Calgary Alberta company that is very helpful and accommodating...

http://www.clearcutmetal.com/

Rob!

 

[richard j]

sam. mark is a good guy to talk to. i just tried to call him but no answer. i'll have him contact you.

 

[Sam Salvati]

I just PM'd him Rich, thanks though!

Rob, thanks but this is big stuff I'd like to keep shipping down.

 

[Sam Salvati]

thanks dudes!

 

[jll346]

Sam, Can it be done on a CNC? If so I have someone I use in Bloomingburgh. BIG fabrication shop and a super nice guy....

Jim

 

[Sam Salvati]

It could be, but I think it'll be more costly.

 

[butcher_block]

sam let me look into something i ll call you tomorrow about the thing you talked to deker about

they are hungry i hear

 

[Sam Salvati]

Rockin Butch.

 

[jll346]

It could be, but I think it'll be more costly.

If I can help by asking let me know.

 

[Sam Salvati]

If I can help by asking let me know.

email sending J, thanks

 

[butcher_block]

sam i was told that cause you have round bar that the laser will have problems (it has to focas the beam a t a hight and the hight woudl change over the hup in the bar causeing problems. same goes for waterjet

the local cnc guy might be able to get to it in a month or more

 

[Sam Salvati]

I'm going to talk to Uncle Aldo tomorrow at his shindig, then go from there. Probably going to go with square.