What screwdriver heads to work on Benchmade knives?

[Kylaer]

I have a Benchmade Presidio, and the spring holding one-half of the locking bar in place has come loose. I need to open it so I can get it back in place, but as I have discovered, the screwdriver heads needed are rather specific. I tried Allen wrenches, that...didn't work too well.

So, I need one to fit the large axis screw, one for the smaller screws along the sides, and one for the screws holding the pocket clip on (they're coming loose, I need to take them out, Locktite them, and put them back in). What size/style do I need to buy to do this?

Much appreciated, to anyone who knows the answer.

 

[dulleddown]

Torx bit, available from Benchmade (here: http://www.benchmade.com/products/product_detail.aspx?model=981084X ) or other sources....

 

[ziptrickhead]

Im pretty sure all Benchmades use torx 6 and 10. I dont have the Presidio though so I cant be 100% sure.

T10 for the pivot and T6 for the clip etcetc.

 

[Kylaer]

Thank you, I'll check at a local store, and if they aren't there, I'll order some.

 

[ninjajoe]

Torx bit, available from Benchmade (here: http://www.benchmade.com/products/pr...?model=981084X ) or other sources....

I do love that little kit! its so handy to have around when you run into those super small trox screws that you can't find a driver for anywhere.

I just checked it out on my stryker, that one also uses a 6 and 10 like ziptrikhead said.

 

[superdaveviii]

If you have a Lowe's near you, I found these today and while they feel a little cheap, they do do their purpose just fine.