What size torx driver for Benchmade?

dwain

dwain

Joined
May 19, 2002
Messages
484
Does anyone know what size torx driver it takes to remove a pocket clip from a Benchmade 940? I am trying to put on a new one, but I can't find a driver small enough. I tried NAPA, Auto Zone and two local hardware stores. If I have to order one, I need to know the right size. Thanks in advance, Dwain
 
go to lowes or home depot tool section small torx driver bitts go in handle

about 5 or 6 bucks
 
Apparently, the T-6 is used mostly for computer and telephone equipment so keep that in mind when looking for them. They sell them at Radioshack in a 14 piece kit made by Kronos which has both the T-6 and T-8. I have also found T-6 individual screw drivers at Ace Hardware made by General in the telephone/electronics stuff. I even found one in another kit in one of those any tool for $5.49 bins which had both the T-6 and T-8. Sears also carries them as individual screw drivers. I have tried them all except for the Sears ones. What I will say is none of them held up very well for my Buck Mini-Strider because Buck uses blue loctite on their screws. Though my Benchmade Mini-Griptillian was fine and didn't ruin the tips.
 
Home Depot's Husky multi-torx will stand up to Buck's thread-locker. That one works much better than the black and green handled Craftsman torx drivers. It'll be more than adequate for Benchmade's knives.
 
You must log in or register to reply here.
Back
Top