What size Toryx bit for the pocket clip on a Buck 345?

[Pondoro2310]

My pocket clip is rattling.

And where do I find such a small bit?

Thanks!

 

[dogstar]

It is a T6. The same driver is used for all screws on the knife. I just bought a stand-alone screwdriver from my local ACE hardware store. for under $5.

 

[mars5l]

I bought a set of 5 craftsman mini torx set, I think it was like $12. Sizes t8 to i think t5

 

[Pondoro2310]

My local Ace just struck out. I'll try Sears tomorrow.

 

[Allen R.]

Sears, home depot, if you go cheap on the smaller torx you WILL strip your screws or warp your driver, I've been through many a set of torx drivers, get a good set the first time with a lifetime warranty, so far craftsman and husky work best for me.

 

[dogstar]

Sears, home depot, if you go cheap on the smaller torx you WILL strip your screws or warp your driver, I've been through many a set of torx drivers, get a good set the first time with a lifetime warranty, so far craftsman and husky work best for me.

Yup, my ACE T6 driver is warped. Still works fine, though.

 

[Pondoro2310]

I found a T6 at a "Do It" hardware store. I've tightened the pocket clip. I'm now trying to resist the urge to tinker further.

 

[dogstar]

I found a T6 at a "Do It" hardware store. I've tightened the pocket clip. I'm now trying to resist the urge to tinker further.

Tinker away, my friend...
[video=youtube;jLKjOhgZ8Vw]https://www.youtube.com/watch?v=jLKjOhgZ8Vw[/video]