Where does that tiny washer go?

A

Amaranth

Joined
Jul 19, 2009
Messages
421
My attempt to polish the pivot area of the Endura 4 FRN was not as successful as I had hoped. Perhaps I needed to take off more material, and ZDP is a very tough metal to do so. When the pivot screw was tight enough to prevent much bladeplay, the blade seemed a bit sticky. Nothing drastic, but much less smooth than my other E4, one with G10 scales.

Since it the knife has already been reground, the warranty being voided is not an issue with me. I am not worried about my Spydies "breaking"!

But, in getting it back together, I found a tiny washer left on the counter, which I assumed went on the pivot screw.

Did I get it right? I'm sure that it was there for a good reason!
 
THG, those I put in their proper place. The one I'm talking about goes on one of the tiny screws holding the scales on an the knife together, I just wondered which one.
 
Oh, I shouldn't have insulted your intelligence like that lol

Yeah, it belongs on the pivot screw.
 
THG said:
Oh, I shouldn't have insulted your intelligence like that lol! QUOTE]

No worries T,

I have no illusions about my intelligence. I'm right there smack in the middle of the pack.

A lot of people say I'm an idiot for even taking it apart in the first place!
Click to expand...
 
You must log in or register to reply here.
Back
Top