Where to find????

[Dixieblade57]

I am building a knife that I have used silver/nickel to make the bolster and pommel. I am planning on using a 1/16" pin (so as not to draw attention away from the knife itself).

I didn't think I would have a problem finding 1/16" rod/pins to use for the purpose but now that I have the holes drilled out, I can't seem to locate them.

Anyone have a source for a 1/16" silver/nickel rods or pins??

 

[SBuzek]

TKS
http://www.texasknife.com/vcom/product_info.php?cPath=87_35_627_634&products_id=1805

Or if you just need a few inches worth PM or e-mail me your address and I'll mail you a piece.
Stan

 

[Dixieblade57]

Thanks Stan that's what I was looking for exactly!:thumbup: