Where to Get a Clip PVD Coated

[AlaskaBred]

I just purchased a knife here on the Forum but the Ti knife clip has scratches. I'd like to get it re-coated in black pvd....any recommendations would be appreciated.
Thanks gang!

 

[SharpBits]

I was curious enough to look it up. As a start, search for Brazen Firearms. I have never used them, but they do PVD and other coatings for small parts. I'm sure there are others that offer firearm parts coatings out there as well.

 

[adluginb]

Vulcan machine works is another. Thinking about sending a whole knife in to get DLC’d.

 

[AlaskaBred]

Thanks guys for the suggestions, I'll take a peek at those sites. Just hope it doesn't cost too much. I did a half-hearted search earlier and kept running into industrial applications.

 

[AlaskaBred]

Vulcan machine works is another. Thinking about sending a whole knife in to get DLC’d.

Good idea, got me thinking about getting a blue mordax blade dlc'd. That would look sweet.

 

[DA170]

I’ve used West Coast PVD for knife and off road vehicle parts.

 

[AlaskaBred]

I’ve used West Coast PVD for knife and off road vehicle parts.

I'll shoot them an email as well. Thank you.

 

[AlaskaBred]

I was curious enough to look it up. As a start, search for Brazen Firearms. I have never used them, but they do PVD and other coatings for small parts. I'm sure there are others that offer firearm parts coatings out there as well.

Looks they do small parts for 10 clamz. That should work, thanks again.

 

[AlaskaBred]

Brazen will do it. Vulcan would not.

 

[jmh33]

Scratch’s on PVD over silver is going to be a lot more noticeable than alone.
Just a thought!!
John

 

[AlaskaBred]

Scratch’s on PVD over silver is going to be a lot more noticeable than alone.
Just a thought!!
John

this isn't going to be an edc.

 

[jmh33]

this isn't going to be an edc.

Gotcha!!
John

 

[GrumpySoreOldBastard]

Wayofknife