- Joined
- Jan 9, 2011
- Messages
- 416
Here is a recurve chopper & battle buddy I recently finished. Specs as follows:
Recurve Chopper- A2 steel at 60Rc, convex ground, convex edge, black wrinkle powder coat, 13 1/2 OAL, 8 1/4 grip to tip, 2 3/8 at its widest point, 1/4 thick. Coyote G10 scales fastened with machine screws and stand offs.
Battle Buddy- D2 steel at 60Rc, convex ground, convex edge, bit of a stone washed finish, 7" OAL, 3 1/8 grip to tip, 1" wide, 1/8 thick. Coyote G10 scales fastened with epoxy and stainless hollow tubes. Thanks for looking and have a good one!
Recurve Chopper- A2 steel at 60Rc, convex ground, convex edge, black wrinkle powder coat, 13 1/2 OAL, 8 1/4 grip to tip, 2 3/8 at its widest point, 1/4 thick. Coyote G10 scales fastened with machine screws and stand offs.
Battle Buddy- D2 steel at 60Rc, convex ground, convex edge, bit of a stone washed finish, 7" OAL, 3 1/8 grip to tip, 1" wide, 1/8 thick. Coyote G10 scales fastened with epoxy and stainless hollow tubes. Thanks for looking and have a good one!
