- Joined
- May 3, 2002
- Messages
- 6,192
I KNOW; I just KNOW someone on this forum HAS to be good at drilling and tapping knives so that pocket clips can be switched from one side to the other or from tip-down to tip-up?
Who out there can do this work?
Who is it?
Who can do it RIGHT?
Who guarantees their work?
Who has feedback saying they can do it right?
I want to do it with two Emersons and a Timberline Wortac and, perhaps, a few others, but I want someone who can do it right and not botch the job. I'd rather pay extra to have Emerson Knives or somebody like that do it than have someone botch the job. BUT, I'd TOTALLY rather spend a few dollars less to support an individual in this knife community that does good work and can turn a job around a little faster.
Who out there can do this work?
Who is it?
Who can do it RIGHT?
Who guarantees their work?
Who has feedback saying they can do it right?
I want to do it with two Emersons and a Timberline Wortac and, perhaps, a few others, but I want someone who can do it right and not botch the job. I'd rather pay extra to have Emerson Knives or somebody like that do it than have someone botch the job. BUT, I'd TOTALLY rather spend a few dollars less to support an individual in this knife community that does good work and can turn a job around a little faster.
