Photos Your shop showroom, or how do you display your knives.

PEU

PEU

Gaucho Knifemaker
Joined
Aug 6, 2006
Messages
1,162
Hi Guys, after many years I'm reshuffling my shop so the space available is better used. I'm looking for ideas on how to setup a space to show the available knives, I'm thinking something like a wooden tribune like the photo (but table sized) where I can put many knives without using a whole table.
Also I have a ton of hardened blanks that would like to get organized, so I'm open to ideas on that front too.

Thanks

Pablo

dZlABfK.png
 
For hardened blanks a lot of makers have nails in the wall. Simply hang the blanks from them (assuming they have pin holes drilled in them). Very nice if you have batches of the same pattern since they stack well.
I use a whiteboard with nails across the top. That way I can write notes pointing to the blades.
 
PEU said:
Hi Guys, after many years I'm reshuffling my shop so the space available is better used. I'm looking for ideas on how to setup a space to show the available knives, I'm thinking something like a wooden tribune like the photo (but table sized) where I can put many knives without using a whole table.
Also I have a ton of hardened blanks that would like to get organized, so I'm open to ideas on that front too.

Thanks

Pablo

dZlABfK.png
Click to expand...
Until I read your post I through that was a set of Bleacher's. Wow, you must have a lot of knives to show if you need bleachers!
 
  • Haha
Reactions: PEU
You must log in or register to reply here.
Back
Top