ZT 0350 off center again

[Random Dan]

A couple months ago I was having troubles with the blade of my ZT 0350 rubbing against the liner. I posted a topic here, and a couple people recommended loosening all the screws, wedging the blade with a few pieces of paper, and retightening all the screws. I tried that a few times and it didn't help, so I sent it in to Kershaw's warranty department. About a month ago it came back perfectly centered, and I was happy again. But over the past month of using it the blade has worked it's way off center again (same side), almost to the point where it rubs against the liner. I tried the same recentering technique listed earlier, and again it didn't work. I am now thoroughly cheesed off Any one have any ideas of what I could do?

(I also posted this in the maintenance/tinkering forum 'cause I wasn't sure where it should go.)

 

[knivesandguns]

Have you tried tightening the pivot slightly? Sometimes just that simple of a tweak can fix many things.

 

[C.M.L]

A couple months ago I was having troubles with the blade of my ZT 0350 rubbing against the liner. I posted a topic here, and a couple people recommended loosening all the screws, wedging the blade with a few pieces of paper, and retightening all the screws. I tried that a few times and it didn't help, so I sent it in to Kershaw's warranty department. About a month ago it came back perfectly centered, and I was happy again. But over the past month of using it the blade has worked it's way off center again (same side), almost to the point where it rubs against the liner. I tried the same recentering technique listed earlier, and again it didn't work. I am now thoroughly cheesed off Any one have any ideas of what I could do?

(I also posted this in the maintenance/tinkering forum 'cause I wasn't sure where it should go.)

I'm sure it's a pain in the ass but send it it again...let them know this is the second time.