Zt 0561 blade centering help

[Ginger9112345]

I recently purchased a zt off of eBay and have looked around to try and find how I can move my blade over a millimeter or two and there is nothing on this subject could someone help me out

 

[RevDevil]

Tighten the pivot all the way down.

 

[kershawTEX]

I learn his trick from riding many years of fixed gear biking to tighten down the back wheel. I applied this to a few production knives I recently recieved that were off center. First: loosen the pivot hardware all the way Second: push the blade all the way to left. Third: While keeping pressure on blade fully tighten pivot. Next loosen it a tad till blade can move, REPEAT till desired resulted are achieved. It takes a bit to get it down, but I just did it on a Kershaw Knockout and Kershaw RJ martin stainless steel.

 

[Ginger9112345]

Thanks for the advise once I wake up tomorrow I'm doing this right away cheers

 

[kershawTEX]

hey ginger, that work for u at ?

 

[Ginger9112345]

Yea kershaw thanks it took about 5 minutes really easy