ZT 0562TI

I would say they should be even. I have a 0562CF, and the "thumbstud" blade stops protrude the same amount on both sides. I have never seen a 0562TI, but I would assume they should be the same.
 
I’m sure you could tap it back centered.
Should be a easy fix just be gentle :thumbsup:
 
I just checked my 562ti & the blade stop is even on both sides.
 
My 562cf is offset... Doesn't bother me because it sticks out more on the lock side, and less on the show scale, which makes sense since you don't want the blade stop hitting CF. On the ti I'd imagine it would be centered. But if it's not it shouldn't hurt anything.
 
Ironbut said:
I just checked my 562ti & the blade stop is even on both sides.
Click to expand...

Is your 0562 an earlier or later model. I'm wondering if when they started making the titanium version the were still offsetting the blade stops like on the g19 and cf versions
 
I got 6 0562 including 3 Ti version. All of them are slightly off either on one side or another. But not severe and you really have to look hard to notice the uneveness. These are all press fitted so it’s probably hard to be 100% even.
 
soc_monki said:
My 562cf is offset... Doesn't bother me because it sticks out more on the lock side, and less on the show scale, which makes sense since you don't want the blade stop hitting CF. On the ti I'd imagine it would be centered. But if it's not it shouldn't hurt anything.
Click to expand...

No. ZT 0562 is carefully designed such that in the locked position the stop pin only contacts the steel liner but not the cf (or g10) scale. Look at that area closely and you will see what I mean.
 
sharp_edge said:
No. ZT 0562 is carefully designed such that in the locked position the stop pin only contacts the steel liner but not the cf (or g10) scale. Look at that area closely and you will see what I mean.
Click to expand...
I have, and they machined the CF so the pin wouldn't hit it. Still doesn't bother me, knife works just fine. It's hardly noticeable anyway.
 
mauser133 said:
Is your 0562 an earlier or later model. I'm wondering if when they started making the titanium version the were still offsetting the blade stops like on the g19 and cf versions
Click to expand...

I got it as soon as they became available, then gave my old G10/Elmax version to my son.
 
You must log in or register to reply here.
Back
Top