ZT0200 Where can I get replacement pillars and screws etc. or aftermarket?

[Stxwrx]

I acquired a used ZT0200 and the body screws and the pillars have all been cross threaded. I discovered this when I took it apart to for inspection and first cleaning in my possession. Needless to say I was not happy with this observation. :barf: Not much I can do about so I want to fix it up with new hardware.

I like the knife but I can not find any place to get replacement hardware nor can I find any clear indication that the 0200 shares hardware with other ZT models. (I am sure it must...) I do know it does not use the same pillars as my 0561.

Also does any one have reference to the actual hardware specifications like screw size and thread pitch? I have not measured yet to figure that out since things are so beat up. It would much simpler to have a reference of those specifications.

I have not contacted ZT as of yet but I am sure I can send them the knife to get it all factory fixed up. I'd love to find Bronze Ti hardware for it and just ditch the tore up factory hardware.

Thanks in advance for any guidance or knowledge share-

 

[Stxwrx]

So ZT customer service is excellent yet again. I merely sent an email inquiry trying to confirm the thread specifications. Their simple reply was that a full replacement hardware kit is on it's way. I already have the tools necessary but they even included recommendations as to where to get the right tools. Very impressed.