ZT0560, smoothening the jimping?

sogflash

sogflash

Joined
Aug 28, 2011
Messages
1,600
Has anybody tried to smoothen the jimping on a 0560? How should it be done?

It's one of my favorites, but the aggressive jimping hurts my palm too much.
 
The only suggestion I have is to use it a lot and build up calluses on your palm. Then, it won't hurt as much. Other than that, maybe some extra fine sandpaper just to knock off the sharp edges of the jimping.
 
I find it a bit rough as well. I was going to smooth it out, but decided it would be good to leave it alone. It's pretty grippy which can be a good thing.
 
Sharp jimping sucks.

Actually, most jimping sucks, but it looks kinda cool.

You can definitely adjust it to suit your usage with 320-400grit wet/dry.
 
sogflash said:
Yes, seriously. Cutting something with some resistance, not paper or cardboard, but wood does hurt.
Click to expand...


The problem is clear now.

Try using the chain saw. :D

(just teasin dude)

Honestly, If I were you, I would not try to modify the knife. 99% of the time, the jimping won't be any issue.

Just use a cheap pair of leather gloves when the going gets tough. You will maintain the security of the jimping, without wearing on your skin.

JMHO
 
sogflash said:
Did you take the knife apart first?
Click to expand...

No, you can do it rather easily without taking the knife apart. With the blade open and locked, work on the perpendicular, using the triangle edge down in the grooves. Then, unlock the blade and let it hang down at 90 degrees, so that the thumb assist is hidden in the handle. May I suggest taping the edge for some added protection while doing this. Then use the full length of the rod, paralell with the handle, working length ways, smoothing one side of the edge/corner of the liners at a time.

It's a very simple, quick, and effective procedure. Takes maybe 5 minutes. In fact, I've had to do on several ZT/Kershaw knives.
 
Last edited:
You must log in or register to reply here.
Back
Top