1/4"x11/2" 1084 DELIVERY DATE

[Aldo Bruno]

I recieved conformation on the order of 1/4" x 11/2" 1084. The rolling date is Sept. 16th and I am expecting a delivery date the last week in September. I decided on a cut length of 4 foot so as to lower shipping costs.(UPS charges extra for anything over 60 inches)

Upon recieving the load three random pieces will be sent out to an independant testing lab. I will be posting the averages of these 3 tests and sending out the results of all 3 upon request with your order.

Shipping should start the 1st week of October. I will also be bringing bars to the Dixie Hammer-In. IF YOU PLAN TO GO AND WANT TO PICK IT UP THERE PLEASE LET ME KNOW ASAP. My van can only hold so much and I've already got quite a few orders going.

If interested please contact me at stovetop58@yahoo.com. PLEASE send a ZIP CODE and the amount you would be interested in. As mentioned in my last post price per pound will be $3.25 with a .25 break at 100 and 300 pounds. If you wish to order together with friends or with a group or organization you may be long to let me know and we can discuss it further.

Thank you,

Aldo Bruno
New Jersey Steel Baron

CONTACT INFO.
stovetop58@yahoo.com Phone# 201-637-1413

We also have 1/4" x 1" x 6ft 1084 and 5/8" x 4ft W-2 round bar in stock

 

[deker]

Aldo,

Thanks for putting this together. I'm hoping to be able to free up some $$ to put in an order from you. It's been a little tough lately w/ 2 weeks off work unpaid after a car accident though...at least I walked away from the wreck

-d

 

[Don Hanson III]

Aldo, the check is in the mail, I'll be looking for mine soon after you receive the shipment.

 

[Aldo Bruno]

Deker,I'm in the Plumbing bus. by trade and if there's one thing I know is s#@t happens. Call me and we can discuss it.

Don, You'll be the 1st bunch out. Hope to see lots of pretty thing come out of it!

 

[sgmtino]

would be interested in a couple bars

 

[Kaliandk9s]

I'll take two pieces. Just let me know how much for shipping. If it gets too pricey I might make the drive down to NJ. How did the plumbers knife turn out? Also, do you still have that VFD motor and controler.

Greg