1/8 x 1/8 in. tool steel stock...

[anvilring]

Anyone know where to get such as this by the foot? I really don't want to have to saw up a 1" bar. I need it 1/8x1/8. O1 preferably.

regards, and thanks for any responses.

mitch

 

[KnuckleDownKnives]

Check online metals they have O1 in square stock as small as 1/8"

 

[kuraki]

https://www.mcmaster.com/#tool-steel/=1693jxp

They have 1/8 x 1/8 pg O1.

 

[anvilring]

Thanks folks!

 

[Don Hanson III]

I've bought it at MSC, but it's been years ago.

 

[Drew Riley]

https://www.mcmaster.com/#tool-steel/=1693jxp

They have 1/8 x 1/8 pg O1.

Is there anything they don't have?

I had to rush over to the Elmhurst, IL facility a few weeks ago to get a 6' piece of 2" round W1 for an emergency shaft replacement on a dryer, and, I'm not kidding, that place is YUUUUUUGE.
Took me almost 10 minutes to drive around the "building" looking for the "will call" doors. Looked like they had HUNDREDS of truck docks. It was awe inspiring. I'd love to take a tour of the place.

 

[kuraki]

Me too. Really well run operation.