1084 & Red Stag Hunter w/Hamon (sold)

Alan Davis Knives

Alan Davis Knives

Knife Maker
Feedback: +185 / =0 / -0
Joined
Jun 28, 2010
Messages
2,249
overall length - 9 7/8"
blade - 5" from tip to guard x 1 1/4" high
steel - Aldo's 1084 differentially heat treated w/ edge at rc 59-60
finish - 800 grit hand rubbed w/ hamon line
grind - hollow on 10" wheel
handle - premium Red Stag
guard - wrought iron, etched to bring out pattern w/ some forge marks
sheath - right hand leather by maker
spacer - black fiber

This one has a very large handle, about 1 7/8" high x 1 1/4" wide at the pommel

(SOLD) 265.00 + $15 shipping with insurance in the US, international extra. Paypal, money order and most other forms of payment. Thanks for looking, Alan.

RedStagHunter019.jpg


RedStagHunter023.jpg


RedStagHunter027.jpg


RedStagHunter033.jpg


RedStagHunter008.jpg


RedStagHunter039.jpg
 
Last edited:
Alan, you're stuck in a rut...................Everything that you've been making for a quite a while Looks Fantastic!!!
 
Mick57 said:
Very nice, both knife & sheath. Is there a cap on the butt end?
Click to expand...

There is not a butt cap, what little pilf there was is filled with CA and polished. I can get a shot of it if you would like. (I could add a butt cap in wrought iron)

Thanks,
Alan
 
That hamon is about as good as it gets, amazing work Alan!!! :thumbup:

I can't wait to get my order from you so I can place another one!
 
Alan Davis Knives said:
There is not a butt cap, what little pilf there was is filled with CA and polished. I can get a shot of it if you would like. (I could add a butt cap in wrought iron)

Thanks,
Alan
Click to expand...


No, that's fine. If I did buy it, I'd definitely go with you adding the end cap. Thanks.
 
You must log in or register to reply here.
Back
Top