I'm not sure how, but I kinda botch the scales a bit on this skinner. It looked OK when I clamped it. I guess the shop gremlins got to it. Pics show the details.
I'm asking $60 + $8 shipping.
I was going to make a sheath, but I only have tools for Kydex right now and this one would look much better in leather.
Specs:
Steel: 1084
Scales: Walnut Dymondwood w/red liners
OAL: 8 1/4"
Blade tip to handle: 3 7/8"
Blade width: 1 1/4" at the plunge
Spine: 1/8"
Blade is oil quenched and satin finished.
Thanks for looking.
This photo shows the gap between the wood and the liner on the tang.
This photo shows the gap up near the ricasso.
I'm asking $60 + $8 shipping.
I was going to make a sheath, but I only have tools for Kydex right now and this one would look much better in leather.
Specs:
Steel: 1084
Scales: Walnut Dymondwood w/red liners
OAL: 8 1/4"
Blade tip to handle: 3 7/8"
Blade width: 1 1/4" at the plunge
Spine: 1/8"
Blade is oil quenched and satin finished.
Thanks for looking.
This photo shows the gap between the wood and the liner on the tang.
This photo shows the gap up near the ricasso.
