- Joined
- Jul 8, 2008
- Messages
- 1,079
Forged 1095 and lacewood hunter!
OAL- 8 1/2"
blade- 4 1/16" long, .155" thick, 7/8" wide at the guard
steel- Forged Aldo's high carbon 1095, with in-house differential heat treatment
grind- a full flat grind, with distal taper
finish-etched 600 grit finish
handle-lacewood with red spacer, tru-oil finish
guard- 1/4" brass and 1/8" brass pins
sheath- 10oz leather, hand stitched, hand tooled, hot-waxed, with cam, for "snap fit", 3 copper rivets for belt loop
blade fully tested for edge retention and tip strenth before finishing
the handle had a small void on the left side next to the front pin, I filled it with exopy, and is a cosmetic flaw only.
$130 plus $10 shipping/insurance to CONUS. I can accept paypal Joe357m@bresnan.net or money order.
First one to post "I'll take it" gets it!!!
Ships within 48 hours of payment, priority with insurance.
Feedback appreciated, and thanks for looking!
If you would like one like this one, or something different, email, or PM with details.
OAL- 8 1/2"
blade- 4 1/16" long, .155" thick, 7/8" wide at the guard
steel- Forged Aldo's high carbon 1095, with in-house differential heat treatment
grind- a full flat grind, with distal taper
finish-etched 600 grit finish
handle-lacewood with red spacer, tru-oil finish
guard- 1/4" brass and 1/8" brass pins
sheath- 10oz leather, hand stitched, hand tooled, hot-waxed, with cam, for "snap fit", 3 copper rivets for belt loop
blade fully tested for edge retention and tip strenth before finishing
the handle had a small void on the left side next to the front pin, I filled it with exopy, and is a cosmetic flaw only.
$130 plus $10 shipping/insurance to CONUS. I can accept paypal Joe357m@bresnan.net or money order.
First one to post "I'll take it" gets it!!!
Ships within 48 hours of payment, priority with insurance.
Feedback appreciated, and thanks for looking!
If you would like one like this one, or something different, email, or PM with details.