- Joined
- Jul 8, 2008
- Messages
- 1,079
A very nice hunter in 1095 and tiger maple!
OAL- 8 3/4"
blade- 4 3/16" long, .150" thick, 3/4" wide at the guard
steel- Aldo's high carbon 1095, Forged, with in-house differential heat treatment
grind- a full convex grind, with distal taper
finish- etched 600 grit finish, with hamon
handle- a very nice piece of tiger maple, lightly dyed with tru-oil finish
guard- 1/4" brass, and 1/8" brass pin
sheath- 11oz leather, hand stitched, hand-tooled, hot-waxed, 3 copper rivets for belt loop
blade fully tested for edge retention and tip strenth before finishing
$130 plus $10 for shiping/insurance to CONUS. I can accept paypal Joe357m@bresnan.net or money order.
1st to post "I'll take it" gets it!!!
Ships within 48 hours of payment priority with ins.
Feedback appreciated, and thanks for looking!
If you would like one like this, or a different one, email or PM with details.
OAL- 8 3/4"
blade- 4 3/16" long, .150" thick, 3/4" wide at the guard
steel- Aldo's high carbon 1095, Forged, with in-house differential heat treatment
grind- a full convex grind, with distal taper
finish- etched 600 grit finish, with hamon
handle- a very nice piece of tiger maple, lightly dyed with tru-oil finish
guard- 1/4" brass, and 1/8" brass pin
sheath- 11oz leather, hand stitched, hand-tooled, hot-waxed, 3 copper rivets for belt loop
blade fully tested for edge retention and tip strenth before finishing
$130 plus $10 for shiping/insurance to CONUS. I can accept paypal Joe357m@bresnan.net or money order.
1st to post "I'll take it" gets it!!!
Ships within 48 hours of payment priority with ins.
Feedback appreciated, and thanks for looking!
If you would like one like this, or a different one, email or PM with details.
