- Joined
- Jan 10, 2007
- Messages
- 1,924
When I designed my Altoid's tin survival neck knives I set them up so that I could also put handle scales on them. However, I just hadn't gotten around to it. That is until this past week! The result is this knife. The first of my survival tin knives to get handle scales.
In this picture I still need to sharpen the blade, hand sand a little, and make a sheath. However, all that has now been done. When my wife gets home later this evening with the camera I will put up a finished picture.
The knife has a blade length of about 1 1/4'' and the overall length is about 3 1/2''. The scales are an olive drab G-10 and the blade is 3/32'' 1095 high carbon steel. It comes with a kydex neck sheath and ball chain. The price on this one is SOLD.
You can check out a couple of the progress photos here in my new forum.
In this picture I still need to sharpen the blade, hand sand a little, and make a sheath. However, all that has now been done. When my wife gets home later this evening with the camera I will put up a finished picture.
The knife has a blade length of about 1 1/4'' and the overall length is about 3 1/2''. The scales are an olive drab G-10 and the blade is 3/32'' 1095 high carbon steel. It comes with a kydex neck sheath and ball chain. The price on this one is SOLD.
You can check out a couple of the progress photos here in my new forum.
Last edited:
