2 beauties, one in W2 w/hamon, and one in CPM 3V!!!

R

rjfm1972

Feedback: +10 / =0 / -0
Joined
Jan 13, 2013
Messages
221
I have up for your consideration a couple of real beauties here. The first is a Japanese style blade in W2, differentially heat treated to show a beautiful hamon, and the other is a heavy duty CPM 3V camp/survival knife. I designed the handle on the 3V blade with a groove running the center of the length of the handle, so that it can be tied to a stick to make a useful spear with. A lot of time went into these 2 blades. I hope you like.

W2 tanto w/hamon
Blade is 3/16" thick, 4 1/2" long
Overall length is 8 5/8"
Handle is stabilized redwood burl, w/ red G10 liner, pins are 316L stainless steel
Two toned heavy duty leather sheath (included) has a belt clip on back
I am asking $175.00, first I'll take the tanto, gets it!








Next up is the CPM 3V camp/survival
Blade is .200" thick 4 1/2" long CPM 3V, heat treated by Peters heat treating, and cryogenically treated to RC 60-61
handle is bush cam G10 with stainless steel screws
overall length is 9 1/4"
sheath (included) is black leather in front, and black kydex in back with a large tek-lok (also included)
I am asking $225.00 for this beauty. First I'll take the Camp knife gets it!

Thank you for looking!









 
I'll take the tanto!! Do you accept paypal? And what grind I used on it, does it have a secondary bevel or is it a full flat, v grind, or flat to convex?
 
The Tanto is beveled along the spine, but not to a sharp edge. It was ground flat, and polished to very slightly convex.
 
You must log in or register to reply here.
Back
Top