- Joined
- Dec 28, 2013
- Messages
- 118
Here are two friction folders I made a few years ago that have just been sitting in the case.
I had kind of forgotten about them until I was cleaning the studio a while back.
The handles are solid antler. There is no spacer added. I carved out the middles for the blade to fit.
They both open and close snug.
There are a few reasons I'm listing these lower than my usual range.
1. These are not my damascus. The blades are made from Alabama Damascus Steel. I did do the heat treat.
2. I've had these for a while and just want someone to enjoy them.
3. They don't come with a sheath.
#1 - This is the larger of the two.
Alabama Damascus
antler tip with file work
stainless pin and domed pivot washers
.005" bronze washers inside
6" open
3 1/2" closed (not including flipper)
2 7/16" edge
3/32" thick at the spine
tiny bit over 9/16" at the widest
$100 + $10 shipping in the US
Post here, PM me or email me at smetaldesigns @ gmail.com
#2 - The smaller of the two. I really like the file work on this one.
Alabama Damascus
antler tip with file work
stainless pin and pivot washers
.005" bronze washers inside
4 5/8" open
2 3/4" closed (not including flipper)
1 13/16" edge
3/32" thick at the spine
tiny bit under 9/16" at the widest
$100 + $10 shipping in the US
Post here, PM me or email me at smetaldesigns @ gmail.com
Thanks for looking.
Shelby
I had kind of forgotten about them until I was cleaning the studio a while back.
The handles are solid antler. There is no spacer added. I carved out the middles for the blade to fit.
They both open and close snug.
There are a few reasons I'm listing these lower than my usual range.
1. These are not my damascus. The blades are made from Alabama Damascus Steel. I did do the heat treat.
2. I've had these for a while and just want someone to enjoy them.
3. They don't come with a sheath.
#1 - This is the larger of the two.
Alabama Damascus
antler tip with file work
stainless pin and domed pivot washers
.005" bronze washers inside
6" open
3 1/2" closed (not including flipper)
2 7/16" edge
3/32" thick at the spine
tiny bit over 9/16" at the widest
$100 + $10 shipping in the US
Post here, PM me or email me at smetaldesigns @ gmail.com
#2 - The smaller of the two. I really like the file work on this one.
Alabama Damascus
antler tip with file work
stainless pin and pivot washers
.005" bronze washers inside
4 5/8" open
2 3/4" closed (not including flipper)
1 13/16" edge
3/32" thick at the spine
tiny bit under 9/16" at the widest
$100 + $10 shipping in the US
Post here, PM me or email me at smetaldesigns @ gmail.com
Thanks for looking.
Shelby
