Jack O'Neill
Gold Member
- Joined
- Nov 15, 2007
- Messages
- 7,193
Good afternoon folks , I have these 2 newly finished B & T's to offer .
They have a full height flat grind with a hand sanded finish . They were ground from 7/64 A-2 tool steel bar stock and heat treated to an Rc. 61-62 with the sub-zero quench .
The overall length is 8-1/4 with the blade at 3-1/2 , 5/8 wide and a sharpened edge at 3"
The 1st one up I also ground into the spine to thin the blade down even more , the spine measures .053 at the plunge line and tapers to the point .
It is handled up in Orange Tero-tuf with blue liners and brass Corby Bolts .
Orange tero-tuf now sold .
The sheaths for both are ambidextrous carry .
2nd up is handled in Coyote Brown Tero-tuf with green liners and brass Corby bolts .
$135.00 for each , shipping included in the USA, Pay-pal , postal M/O or check held to clear .
My PP is sandlot@charter.net .
Hope you all like them and comments are always welcome and appreciated .
They have a full height flat grind with a hand sanded finish . They were ground from 7/64 A-2 tool steel bar stock and heat treated to an Rc. 61-62 with the sub-zero quench .
The overall length is 8-1/4 with the blade at 3-1/2 , 5/8 wide and a sharpened edge at 3"
The 1st one up I also ground into the spine to thin the blade down even more , the spine measures .053 at the plunge line and tapers to the point .
It is handled up in Orange Tero-tuf with blue liners and brass Corby Bolts .
Orange tero-tuf now sold .
The sheaths for both are ambidextrous carry .
2nd up is handled in Coyote Brown Tero-tuf with green liners and brass Corby bolts .
$135.00 for each , shipping included in the USA, Pay-pal , postal M/O or check held to clear .
My PP is sandlot@charter.net .
Hope you all like them and comments are always welcome and appreciated .
Last edited:
