1) Now rare XM-24 Stonewashed Skinny Slicer with black hardware and G10 scale, Hinderer Logo clip and filler. Running on PB washers, very smooth and flips well. If you want the original Teflon washers, I can send you some. No box. $SOLD TYD
2) XM-24 Working Finish Spanto with OD green G10 scale, MXG deep pocket clip and counter-sunk filler tab. Currently runs very smooth on bearings. With original box, remaining tri-way kit, pocket clip, adjustment card, etc. The original filler tab is underneath the MXG clip. I don't have the original blue G10 scale anymore. $SOLD TYD
Both have original factory edges, and have not been used for cutting. Both have Ti Torx (T6 + T10) hardware; original clip and scale screws will be included in the package.
USPS insured shipping, Paypal G&S, US only.
If you want to buy, say so in this thread, followed by a PM. I reserve the right to sell to whomever I choose.
Thanks for looking !
Roland.
2) XM-24 Working Finish Spanto with OD green G10 scale, MXG deep pocket clip and counter-sunk filler tab. Currently runs very smooth on bearings. With original box, remaining tri-way kit, pocket clip, adjustment card, etc. The original filler tab is underneath the MXG clip. I don't have the original blue G10 scale anymore. $SOLD TYD
Both have original factory edges, and have not been used for cutting. Both have Ti Torx (T6 + T10) hardware; original clip and scale screws will be included in the package.
USPS insured shipping, Paypal G&S, US only.
If you want to buy, say so in this thread, followed by a PM. I reserve the right to sell to whomever I choose.
Thanks for looking !
Roland.
Last edited:
