3 blades

[NickWheeler]

Hi Guys-

All 3 are sold... Thanks fellas! I have been planning on finishing these myself, but it hasn't happened... so I'm letting 'em go.

All 3 are fully flat ground to a thin edge with a touch of convex geometry. Tangs & flats are surface ground nice and flat.

#1- 52100 at 59/60C
OAL- 8-5/8"
Blade- 3-7/8"L x 15/16"W x 1/8" thick
SOLD $60 shipped in the states

#2- O1 at 59/60C
OAL- 8-3/16"
Blade- ~3-1/2"L x 7/8"W x 0.145" thick at ricasso (tapered tang)
SOLD $70 shipped in the states

#3- 1084 at 59/60C (I don't normally drill a tang out like that, but I wanted to try it to see the effect)
OAL- 8"
Blade- 3-1/2"L x 15/16"W x 0.142" thick
SOLD $55 shipped in the states

Please either post here, and/or contact me via NickWheelerJs at hotmail dot com

Thanks!

 

[canineforge]

Hi, Nick. I'll take #1.

Thanks, Joe

 

[Bama]

I'll take #3 pm your paypal addy

 

[NickWheeler]

You got 'em guys--- Thanks!!!

Pp is Merckman99 at yahoo daught com

 

[bonafide]

I'll take #2

 

[NickWheeler]

I'll take #2

You got it buddy. (#2 is actually my favorite of the 3, I was surprised it was the last to go).

BTW- #2 and #3 were taken down to a burr, and I gave both of them a few swipes on a 600X DMT stone... so they're not ballz out sharp, but they're definitely sharp enough to cut you, so please be careful working on them!


Thanks guys!