3 fixed knives with Bohler M390 4,3 mm Hunter K390 3,3 Albion N690 4,5 in G10 - SOLD

[KornalskiKnives]

ODC PM Bohler M390 4,3 mm Stainless Steel in Red G10. HT by myself for maximum stain resistance 59 HRC.
ODC with flat grind. Handles red G10 with stainless steel screws
Stonewash finish, Overall 235 mm, cutting edge 105 mm.
Sheath kydexpl 2 mm - high and low.

SOLD

ALBION HUNTER --> PM Bohler K390 3,3 mm - HT by myself max. wear resistance 62HRC
Thickness on teh top of cutting edge 0.4 mm flat grind almost full
Handles G10 CNC cut fine grit, sure holding even with greese hand + 1 mm yellow spacers.
Finish blade: sandblasted stonewash, cutting edge 25 degrees.
SS torx security screws AISI304 sandblasted M5
Overall: 237 mm, CE 110 mm, handles 115 mm.
Sheath with 2 mm kydexpl

SOLD

ALBION --> Bohler N690 4,5 SS mm - HT by myself 58 HRC
Thickness on top of cutting edge 0.6 mm flat grind almost full.
Handles G10 6,3 mm + 3 mm green spacers.
Finish blade: sandblasted stonewash, cutting edge 25 degrees.
SS torx screws AISI304 sandblasted M5
Overall: 255 mm, CE 130 mm, handles 115 mm.
Sheath with 2 mm kydexpl

SOLD

 

[Bmurray]

These are very nice.

 

[Lu1967]

Very nice indeed.The tamper torxs are a nice touch.Good luck with the sale.

 

[Pirate63]

Nice looking offerings.

 

[Buffalohump]

These look great, I esp like no. 2! Nice work on the sheaths too.

 

[Scott Hanson]

Very nice looking knives :thumbup:

 

[Bmurray]

could that top model be made without clip point, but with a squared spine?

 

[KornalskiKnives]

could that top model be made without clip point, but with a squared spine?

Do You want to have this because You like that way or to make sparks with firesteel?

J.

P.S. Yes I can do any blade You draw but not always want to

Adam

 

[Bmurray]

PM sent

PS. I did look at your FB page and shared it.
Bob

 

[mycough]

Sent you an email with a few questions. Nice work. Russ

 

[KornalskiKnives]

Knives SOLD