timos-
Knifemaker / Craftsman / Service Provider
- Joined
- Oct 22, 2012
- Messages
- 2,164
Hello,
Ive got this available. I cold forged a bit to bring out a pattern in the steel, I call the finish "ghost cloud". The knife model is called "backpacker"
There is plenty of belly in this design, I wanted to get in as much usable edge as I could in a small length.
this one is a bit different than my previous. The handle is a little more slim and has a slight palm swell. Specs below:
Steel: 52100 core/ Stainless cladding from Aldo @ New Jersey Steel Baron
Stock Thickness: just under 1/8"
Heat Treat: RC62 by Jarod Todd
Handle: Stabilized Curly Mango from @daliadesigns
Bevel Geometry: Flat grind to .010" behind the edge, tip is what I call "bushcrafter" its pointy but strong enough to do stuff
Full tang construction
Pins are G10 and mosaic pin tube.
West systems G flex for epoxy
Blade Length: 3-1/4"
Overall length: 7-3/4"
Width at widest point: 1-1/4"
Asking $180.00 shipped CONUS. Thank you for your consideration! Let me know if you have any questions.
Ive got this available. I cold forged a bit to bring out a pattern in the steel, I call the finish "ghost cloud". The knife model is called "backpacker"
There is plenty of belly in this design, I wanted to get in as much usable edge as I could in a small length.
this one is a bit different than my previous. The handle is a little more slim and has a slight palm swell. Specs below:
Steel: 52100 core/ Stainless cladding from Aldo @ New Jersey Steel Baron
Stock Thickness: just under 1/8"
Heat Treat: RC62 by Jarod Todd
Handle: Stabilized Curly Mango from @daliadesigns
Bevel Geometry: Flat grind to .010" behind the edge, tip is what I call "bushcrafter" its pointy but strong enough to do stuff
Full tang construction
Pins are G10 and mosaic pin tube.
West systems G flex for epoxy
Blade Length: 3-1/4"
Overall length: 7-3/4"
Width at widest point: 1-1/4"
Asking $180.00 shipped CONUS. Thank you for your consideration! Let me know if you have any questions.
