52100 Wharncliffe Repost/Price drop

Status
Not open for further replies.
samuraistuart

samuraistuart

Feedback: +43 / =0 / -0
Joined
Dec 21, 2006
Messages
3,158
A simple EDC Warrny!
OAL: 8 3/4"
Blade: 4"
Handle: 4 3/4" (to the front protrusion)
Thickness: .107" at ricasso
Steel: Aldo's 52100 fully normalized and cycled
Wood: Bubinga with Danish and TruOil finish
Edge: 30° inclusive @ 2K finish .010" at shoulder

This was a really fun project! If this one is gone and you want one, I'll make it! Any of my knives, for that matter!
Asking $165 complete with Kydex sheath and belt/boot clip and chicago screws for easy tear down/clean up...and shipping to your door!!! (lower 48 only, anywhere else...we will figure it out)

IMG_0280_zpstey4vneu.jpg


IMG_0279_zpsvwmyt7mm.jpg


IMG_0281_zpsysmsch8y.jpg


IMG_0276_zpsxfij166t.jpg


Paypal address: samuraistuart@yahoo.com Paypal preferred, but will accept checks and money orders.
www.stuartdavenportknives.com
Facebook: Stuart Davenport Knives​
 
surprised no one has picked this up, such a functional knife with some sweet lines.
 
Very nice, this one jumped right out at me. Broke right now but that design really speaks to me. Russ
 
Thanks guys. Here is the kydex sheath. I used chicago screws for easy tear down and clean up. Drain hole and metal boot/belt clip included. Fits perfect.

IMG_0300_zpsk0bwg5o5.jpg
 
Hey Stuart, do you have any C-Tek?

I really like this blade design but I think Id want it in Ctek.
May even buy my own material and send it for you to make.

Im going to add you as a friend if you dont mind and I will get with you down the road a bit.
 
I'd love to purchase this if available...if it's gone, I'd very much like you to make another for me - elegant design!
 
Status
Not open for further replies.
Back
Top