6.5" (165mm) aebl utility - blem SOLD

Status
Not open for further replies.

timos-

Knifemaker / Craftsman / Service Provider
Feedback: +9 / =0 / -0
Joined
Oct 22, 2012
Messages
2,164
AEBL hardened by Peters to RC 61-62
Steel measures about .012 behind edge, pretty robust and very little flex.
Spine is .113 thick and distal taper for last third of the blade.
Excels with blade on board handle off board technique.
220 grit hand rub finish.
Bevels are ground on a 36" radius platen, these slight hollow bevels transition into a FFG bevel about last third of blade. This will ensure little to no thinning required for the life of this blade.

Handle is Walnut ferrule/yellow g10 spacer/ nicely rayed Oak handle. All natural, tung oil finish.
Stainless Steel pin and sealed with West Systems G-Flex.

There is a blemish on spine of handle. It is filled in with epoxy.
Because of this I am asking SOLD shipped to your door (CONUS) for this blade. If you are unhappy with your purchase I will refund within a week of delivery, as long as knife is still in original condition.
Paypal preferred.

There is also a rudimentary "saya" included, Originally this blade was involved in a pass around so I packaged it in the "saya" to ensure safe travels.
I have since refinished the blade and handle but the saya has bonded with the blade now and they seem to be happy with each other :)

12325235_866058366840925_1309514690_n.jpg

12319604_866058280174267_252355187_n.jpg

12309326_866058260174269_755993935_n.jpg

12325342_866058353507593_332428964_n.jpg
 
Last edited:
If anyone is interested in this blade shape , I have 3 more from this batch on deck waiting to be handled and hand sanded. PM or email with any inquiries.
 
Status
Not open for further replies.
Back
Top