This is one I just couldn't fix. I've decided to sell it discounted as blemished. It came from HT warped like a banana. I straightened it with a carbide hammer. Surface ground it. Warped. Straightened again. Rough ground bevels. Warped. Straightened again. Finished bevels. Left alone for a day while the handle epoxy cured. Warped. And then there's some strange lines I could never seem to get rid of on the blade's right side.
Other than that it's a great blade. Very thin. Very sharp.
Blade: 7" CPM Magnacut (63HRC)
Handle: Javanese Teak Burl, silicon bronze pins
Overall length: ~12"
Original price on these is $350. This one is $280 (shipping in US included)
Problems: small warp near the tip (does not impede sharpening), strange wavy lines on the right side of blade
Other than that it's a great blade. Very thin. Very sharp.
Blade: 7" CPM Magnacut (63HRC)
Handle: Javanese Teak Burl, silicon bronze pins
Overall length: ~12"
Original price on these is $350. This one is $280 (shipping in US included)
Problems: small warp near the tip (does not impede sharpening), strange wavy lines on the right side of blade
Last edited:
