Robert Erickson
Knifemaker / Craftsman / Service Provider
- Joined
- Feb 2, 2014
- Messages
- 2,865
Hi guys,
I just finished up this nice little paring knife. It is 9 inches in length with a 4.5 inch full flat ground and hand rubbed blade. The handle material is Satinwood with really nice chatoyance and figure that I wasn't able to fully capture on film.
It's a traditional profile that fits really well in hand and is razor sharp.
OAL: 9"
Blade 4.5" long with full flat grind
Steel: AEB-L 0.10" thickness at the handle with distal taper. HT by Peter's to RC 60
Hand rubbed to 1000 grit. 0.07" behind edge
Handle: Satinwood with SS pins
$125 shipped CONUS. Paypal accepted.
Post I'll take it and PM me with your address and email OR email me at robertericksonknives at gmail dot com
I just finished up this nice little paring knife. It is 9 inches in length with a 4.5 inch full flat ground and hand rubbed blade. The handle material is Satinwood with really nice chatoyance and figure that I wasn't able to fully capture on film.
It's a traditional profile that fits really well in hand and is razor sharp.
OAL: 9"
Blade 4.5" long with full flat grind
Steel: AEB-L 0.10" thickness at the handle with distal taper. HT by Peter's to RC 60
Hand rubbed to 1000 grit. 0.07" behind edge
Handle: Satinwood with SS pins
$125 shipped CONUS. Paypal accepted.
Post I'll take it and PM me with your address and email OR email me at robertericksonknives at gmail dot com
Last edited: