This is a custom neck knife I had Chuck Richards (J.S.) make me about 2 years ago. I think it turned out very well for a neck knife and it has seen some use, but it still has the edge Chuck gave it. As you can see in the pictures it will push cut paper and shave just fine. It has a nice hamon but it can be hard to see in the pictures, I keep this blade oiled. This knife has been used but not abused.
This blade was meant to be tactical and classy while still being useful for EDC tasks. It accomplishes this purpose quite well.
The blade is made out of W2 steel
The blade length is a little over 3 inches, OAL length is under 8 inches.
It has a bolster type guard made out of 416 stainless steel. The handle is dove tailed canvas micarta and it provides a very nice grip.
USPS money order is preferred
I am asking (price reduced) 180 shipped insured priority mail CONUS
You are responsible for obeying all your local, state, and federal laws.
First to post/PM/Email gets it. It is on multiple sites. Thank you all for looking.
This blade was meant to be tactical and classy while still being useful for EDC tasks. It accomplishes this purpose quite well.
The blade is made out of W2 steel
The blade length is a little over 3 inches, OAL length is under 8 inches.
It has a bolster type guard made out of 416 stainless steel. The handle is dove tailed canvas micarta and it provides a very nice grip.
USPS money order is preferred
I am asking (price reduced) 180 shipped insured priority mail CONUS
You are responsible for obeying all your local, state, and federal laws.
First to post/PM/Email gets it. It is on multiple sites. Thank you all for looking.
Last edited:
