A couple of neckers!!!

J

jsmithknives

Feedback: +10 / =0 / -0
Joined
Dec 11, 2008
Messages
393
These are a couple of neckers I made a while back and just finally had the time to finish up!
The first one is a warnie, out of 1/4" 440c ss and both blade and swedge are ground with a 2" wheel.
oveall length: 7 1/2"
blade length: 3 1/2"
edges and holes are bead blasted and all flats and blade have a fine machine satin finish!
This one is SOLD shipped with kydex sheath to conus. All international shipping will be extra, I accept paypal and usps money orders only!
All of your comments are welcome!

DSCN0928.JPG


DSCN0929.JPG


DSCN0930.JPG


This one is again of 1/4" 440c ss with blade and swedge ground with a 2" wheel!
overall length: 5 1/2"
blade length: 2 1/2"
All edges and holes are bead blasted for a better grip, and all flats and blade have a fine satin finish.
This one is SOLD PENDING FUNDS shipped with the kydex sheath to the conus, all international shipping will be extra. I accept paypal and usps money orders!

DSCN0931.JPG


DSCN0933.JPG


DSCN0934.JPG


Thanks for looking!!!
Jason
 
Last edited:
That's all you put out anymore JSMITH, Same ol' Same ol'. Perfection, Perfection, Perfection!!! Will it ever end???;)

Seriously, you put the angle on the dangle here! I love 'em both but MAN, that Wharnie is off the hook!!!

WOW, just WOW! Great work.:thumbup:

Gibby

p.s. PM sent
 
Very nice lines, sleek, well-proportioned, and obvious 1st class F&F. Too bad I was stuck in a meeting that ran past noon! I would have been all over these.
 
You must log in or register to reply here.
Back
Top