- Joined
- Jul 15, 2010
- Messages
- 105
This were built by A.S. Niernberg from Cleveland OK. His is relative unknown, but builds some very fine working knives. I have over 15 of his blades. I have done a couple of deals on here, and got not recorded feedback form them. I understand the ripoff factor with the Internet. I can be referenced by a couple of well known makers on here, if need be.
1st knife is a monster. A cross cut saw blade is how this knife started like. The blade is just a hair over 11 3/4 inches long, 2 5/8 wide and 3/32 thick. Overall it is just over 17 1/2 long. The guard and pommel are brass and the handle is dyed beech. The sheath is massive as well. The finish is good old mustard. The knife handles and swings well. 175.00 plus 10.00 shipping.
#2 is 1074 and 15420 damascus steel. with blue micarta handles 4 3/4 inch blade, 9 inches overall and 3/16 thick at the tang, 7/8 inches deep.. Different pattens on each side. 185.00 and 6.00 shipping. Postal money orders please.
more pictures of the two knives here.
http://s499.photobucket.com/albums/rr360/97hw/Blades/?start=all
1st knife is a monster. A cross cut saw blade is how this knife started like. The blade is just a hair over 11 3/4 inches long, 2 5/8 wide and 3/32 thick. Overall it is just over 17 1/2 long. The guard and pommel are brass and the handle is dyed beech. The sheath is massive as well. The finish is good old mustard. The knife handles and swings well. 175.00 plus 10.00 shipping.
#2 is 1074 and 15420 damascus steel. with blue micarta handles 4 3/4 inch blade, 9 inches overall and 3/16 thick at the tang, 7/8 inches deep.. Different pattens on each side. 185.00 and 6.00 shipping. Postal money orders please.
more pictures of the two knives here.
http://s499.photobucket.com/albums/rr360/97hw/Blades/?start=all