Ok a few questions
If I ask a knifemaker to make a knife, the one sketched below
Can he make a handle out of res-c or something similar? instead of the drawn slab handles, or does it take a factory.
Can he coat the blade? I want it to be made out of 1095.
and can he make it full flat grind while keeping the top of the blade at 3/16th of an inch untill there is about an inch left, even though it curves downward toward the tip?
are those possible?
wanted the blade to be 5 3/4 inch
the handle 4 1/2 inch
blade at widest point 1 5/8 inch
If I ask a knifemaker to make a knife, the one sketched below
Can he make a handle out of res-c or something similar? instead of the drawn slab handles, or does it take a factory.
Can he coat the blade? I want it to be made out of 1095.
and can he make it full flat grind while keeping the top of the blade at 3/16th of an inch untill there is about an inch left, even though it curves downward toward the tip?
are those possible?
wanted the blade to be 5 3/4 inch
the handle 4 1/2 inch
blade at widest point 1 5/8 inch
Last edited: