A quick question about pimping a 0350

F

footballplayerchris

Joined
Jan 1, 2011
Messages
250
Hey guys. Sorry if this is in the wrong area; I wasn't sure where to put it now that the ZT forum is defunct AFAIK.

Anyway, I have a quick question about pimping a ZT 0350.

Does anyone know where I can get red anodized standoffs? I tried searching "red 0350 standoff" on all the popular auction sites but came up empty. I've heard somewhere that Kershaw Blur standoffs will fit? Can anyone confirm or deny that?

Edit: Also, does anyone know where I can source a sculpted clip for the 0350?

Thanks!
 
Last edited:
Post a wanted add maybe. Check with some of the BF craftsmen to see if any of them make that kind of stuff. Look in the gadgets for sale by craftsmen/makers section.
 
You would likely have to get the standoffs custom made, as they are a specific size.....however there will be another issue. The torsion bar that allows for the spring assist is anchored using the scale side liner, and hidden by the backspacer. If you do a standoff conversion you are going to have about 1/16in of the torsion bar showing through.
 
My plan was to remove the torsion bar, I prefer the 0350 as a manual folder. However, when I stopped in at BladeHQ this afternoon, I ended up walking out with a ZT0452CF instead. So I will be pimping that instead. I found anodized screws, a sculpted clip, and anodized standoffs for the 0452CF on Ebay being sold by Gnoleb.
 
You must log in or register to reply here.
Back
Top