G L Drew
Knifemaker / Craftsman / Service Provider
- Joined
- Feb 3, 2005
- Messages
- 4,801
What to do with the end of a bar of steel? Make a handy little knife to carry on the belt, back pocket or glove box.
Stock removal from 1/8 inch 52100 high carbon steel
Heat treated to 60 Rc with a fine grain structure throughout the blade
Distal tapered fulll tang
Flat grind with a 400 grit belt finish
Black canvas Micarta scales
Overall length: 7 inches
Blade: 3 inches
Leather scabbard with a belt loop for a right hand carry. I attached the loop flat against the scabbard to make easy to fit in a pocket or tie onto a pack.
SOLD delivered within these United States. To guard against scams I have not included my email address so please message me for shipping and payment options.
this is a terrible snapshot but I wanted to show off the clip
Stock removal from 1/8 inch 52100 high carbon steel
Heat treated to 60 Rc with a fine grain structure throughout the blade
Distal tapered fulll tang
Flat grind with a 400 grit belt finish
Black canvas Micarta scales
Overall length: 7 inches
Blade: 3 inches
Leather scabbard with a belt loop for a right hand carry. I attached the loop flat against the scabbard to make easy to fit in a pocket or tie onto a pack.
SOLD delivered within these United States. To guard against scams I have not included my email address so please message me for shipping and payment options.
this is a terrible snapshot but I wanted to show off the clip
Last edited:
