Jack O'Neill
Gold Member
- Joined
- Nov 15, 2007
- Messages
- 7,193
Hello everyone , I have this newly finished little EDC to offer up for your consideration . Hope it is well received and remember comments are always welcomed .
This has a high hollow grind from 1/8" A-2 Tool Steel bar stock . Fine scotch-brite belt satin finished and heat treated to an Rc. 61-62 with the sub-zero quench .
It is 6-7/8" overall in length with the blade at 2-7/8" and the sharpened edge at 2-3/4" . Edge to spine at 1"
Handled up in some premium stabilized Wenge with great character and contrast between the black and brown streaks in the wood . With red liners , copper Corby bolts and a couple of nickle silver pins . The sheath is right hand carry .
$135.00 shipped in the USA , others please write for actual shipping cost . Pay-pal , postal m/o or check ( held to clear ) my PP is sandlot@charter.net
Thank you for viewing my offerings.
Jack O'Neill
This has a high hollow grind from 1/8" A-2 Tool Steel bar stock . Fine scotch-brite belt satin finished and heat treated to an Rc. 61-62 with the sub-zero quench .
It is 6-7/8" overall in length with the blade at 2-7/8" and the sharpened edge at 2-3/4" . Edge to spine at 1"
Handled up in some premium stabilized Wenge with great character and contrast between the black and brown streaks in the wood . With red liners , copper Corby bolts and a couple of nickle silver pins . The sheath is right hand carry .
$135.00 shipped in the USA , others please write for actual shipping cost . Pay-pal , postal m/o or check ( held to clear ) my PP is sandlot@charter.net
Thank you for viewing my offerings.
Jack O'Neill
