About to buy Power Tools for a new shop.

I'm goin to the Grizzly store tomorrow. Might come home with a new surface grinder? My old Delta Rockwell has been good, but is long in the tooth, probably set it up to run belts for finishing flats, but the new one will run stone.
 
Last edited:
i can do about 90% of my work witha mini mill and my KMG
i have no drill press since i can use the mini mill for that i have upgraded things over the years like i have a craftsman 12" wood saw and a roll n saw for my steel cutting (this is a killer tool ) got my even heat before my good grinder but then again im not right in the head :) in the last 2 years i picked up a metal lathe a wood one and a bridgport mill but i only use them now and then
if i was goig to spend a bunch of $ at start up i would get a mini mill, 3 speed KMG (upgradable later to VFD) and a 4x6 bandsaw
 
You must log in or register to reply here.
Back
Top