Adding jimping to a folder

[argyle1812]

Not really sure where to post this. I have a ZT 0640 that I would like to have some jimping added to along the spine. Can anyone recommend someone who would do this?

 

[Pinoy Knife]

well since it is already a made /heat treated knife this might be difficult as it has to be done with abrasives /carbide to cut into the hardened blade
good luck on your quest/request..

 

[TheEdge01]

It could be done with an angle grinder and cutting wheel but I would highly advise against that.

 

[Stacy E. Apelt - Bladesmith]

I'll move this to "Services Wanted" in The Exchange.

 

[David Mary]

I can do it.

 

[argyle1812]

I can do it.

Thanks, PM sent