timos-
Knifemaker / Craftsman / Service Provider
- Joined
- Oct 22, 2012
- Messages
- 2,213
Model: Adventure Model
Steel: AEBL @ RC 62 w/ cryo temper (by Jeff Mutz)
Handle: Tapered tang w/ 8th dimension concepts cast acrylic/ aluminum honeycomb substrate
Pins are g10 and mosaic hollow pin.
4" of sharpened edge
Blade finish: rough belt finish w/ visible belt marks. This is a roughly finished user.
Blade Grind: high flat grind with a convexed distal taper. This is ground to slice very, very well. AEBL is pretty tough but lashing this to a stake and using as a spear will result in a tipped blade.
Battening will result in minor chips/bends. However , it would be pretty difficult for this blade to experience catastrophic failure. I know this b/c I have done all these things
I am asking $175 shipped CONUS. I will throw in a can of treehouse too as long as its allowed.
Steel: AEBL @ RC 62 w/ cryo temper (by Jeff Mutz)
Handle: Tapered tang w/ 8th dimension concepts cast acrylic/ aluminum honeycomb substrate
Pins are g10 and mosaic hollow pin.
4" of sharpened edge
Blade finish: rough belt finish w/ visible belt marks. This is a roughly finished user.
Blade Grind: high flat grind with a convexed distal taper. This is ground to slice very, very well. AEBL is pretty tough but lashing this to a stake and using as a spear will result in a tipped blade.
Battening will result in minor chips/bends. However , it would be pretty difficult for this blade to experience catastrophic failure. I know this b/c I have done all these things
I am asking $175 shipped CONUS. I will throw in a can of treehouse too as long as its allowed.
